Tech Edge WBO2 Forum

[KJ16V]

First off can I say Winlog is great piece of software. Cheap and effective!

Hi all, whenever I tune my car I always view logged data in graph mode. However I think matrix mode would be really useful if only I knew how to set it up properly.

Whenever I've tried to set up matrix mode in the past I couldn't get the displayed AFRs to correspond with the values displayed in graph mode, or what was happening in reality. For example matrix mode might show the injectors are switched off at steady cruise loads, where as the real AFR might be 14.3

For example, should I set the rpm values to be the same as the breakpoints the ecu uses? (eg, If two breakpoints are 4000, 4500 and 5000, should I set the matrix values as 4000-4500, and 4501-5000)?

How many samples should I set it to take?

Should I set it to display the average, max, or min AFR in each cell?

Thanks

[KJ16V]

Come on now people, don't be shy!

[Thomas]

Hi.
I am driving a Megasquirt and so I used Megalogviever for analyzing the logs. I am afraid I cannot help you (like many othe TE user as well I suppose).
But maybe you should drop a line at support@devtechnics.com porbably they can give you advice?
Thomas