 |
Tech Edge WBO2 Forum
For Tech Edge Wideband O2 Equipment
|
| View previous topic :: View next topic |
| Author |
Message |
Masi_K
Newbie
Joined: 13 Apr 2009
Posts: 20
|
 Posted: Wed Jun 16, 2010 2:44 pm Post subject: |
 |
|
I'm having similiar issue with 2y0 and winlog 1.02. It connects okay, cannot load log from ecu and rpm shows half speed and no curve from lambda.
I'm not sure did this false reading thingy occurred after replacing hin202 to max232. Tewblog used to mess everything up at connect. I don't know what happens now after chip replace.
-Ibm t20 hardware serial port
-Winxp (with everything updated)
-Selected 4 sparks per engine revolution. Should this be 2 ? |
|
| Back to top |
|
 |
KJ16V
Newbie
Joined: 28 Jul 2008
Posts: 17
Location: UK
|
| Posted: Sat Jun 26, 2010 1:33 pm Post subject: |
|
|
Hi, 'fraid I'm not sure about the other problems but (assuming your engine has four cylinders) yes you should set the sparks to 2. A four-cylinder engine sparks TWICE per revolution! 
About your other problems, have you setup all the device and log configurations, etc? |
|
| Back to top |
|
|
Masi_K
Newbie
Joined: 13 Apr 2009
Posts: 20
|
| Posted: Sun Jun 27, 2010 2:48 pm Post subject: |
|
|
!, yes of course 4cyl engine..  Other settings are okay. But it just does not work. I'll try to figure out something. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
